Lightwave Communications SCS3230 User Manual Page 75

  • Download
  • Add to my manuals
  • Print
  • Page
    / 97
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 74
A Lantronix Company SCS3230 System Administrator's Guide
15.00.038 - 75 - May 2002
8.1 Terminal Card
Each terminal card has four (4) RJ45 connector ports to which a terminal may be attached,
giving a maximum of 16 physically connected terminals per SCS3230 unit. The terminal card
may be installed in slots B, C, D, or E.
To access servers through the SCS3230 terminal card, the user must have at least a text
terminal capable of serial communication, a serial cable terminating in an RJ45 connector, and
the proper serial communication settings as determined by the system administrator. The
default communication settings are 38400, N, 8, or 1.
Once the hardware is properly connected and configured, the user may issue commands to the
terminal card. Before entering any commands, the user should be sure that the terminal card is
ready to accept commands by checking that there is a prompt on screen. This is best
accomplished by pressing <ENTER> until a prompt appears on the screen (a prompt will not
appear on the screen if the terminal port is in direct mode, or if the serial cable is not connected
properly).
8.2 Network Card
The network card must be connected to a network that uses TCP/IP. There is one 10/100 IP
Network port, part of the NETWORK/CONTROL card.
Network settings are entered via the Sys Admin port.
To connect to the SCS3230 network card, the user should use a TCP/IP telnet client to telnet to
the IP address assigned to the network card.
OCTANE_65 10# TELNET 172.16.1.31
Trying 172.16.1.31...
Connected to 172.16.1.31
Escape character is ‘^]’.
Welcome to the SCS3230
You are connected to Port 5 via 172.16.1.31
LCI3200>
8: User Access and Interface
Page view 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 96 97

Comments to this Manuals

No comments