Lightwave Communications SCS3230 User Manual download pdf (Page 63)

A Lantronix Company SCS3230 System Administrator's Guide

15.00.038 - 63 - May 2002

7.4 Deleting a User ID

To delete a user, use the DELETEUSER command, followed by the user ID on the same

line. The LISTUSERS command will allow verification after deleting a user ID. The

following command sequence is an example of the use of DELETEUSER with

LISTUSERS:

sys admin>>DELETEUSER PETE

Delete user:pete Yes or No (N):y

sys admin>>listusers

2: User id > KEVIN

3: User id > TONY

sys admin>>

User IDs may also be deleted by their record number. As each user ID is created, it is assigned

a sequential record number. This number is associated with the user ID and will be displayed

using the LISTUSER command.

sys admin>> deleteuser /3

Delete user:tony Yes or No (N):y

sys admin>>

To delete a user ID using the record number, specify the number as a qualifier after the

DELETEUSER command in the form DELETEUSER /N, where N is the user record number.

7.5 Devices Command

Device port parameters must be defined by the sys admin using the DEVICES

command. If a single device port is to be changed, the port number must follow the

DEVICES command. If the DEVICES command is entered by itself, the configuration of

all device ports will be listed. To edit all possible device ports for a unit, enter the

command DEVICES /ALL.

Programmable elements include: device name, baud rate, stop bits, parity, data bits,

DCE/DTE, flow control and inhibit direct mode. Pressing <ENTER> accepts the

parameter as is. If changes need to be made, each parameter may be edited as it

comes up after each > prompt.

The device name may not contain the * character. If a name is entered with this

character, the administrator will be asked to re-enter the name.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 96 97

No comments

Lightwave Communications SCS3230 User Manual Page 63